Wednesday, October 28, 2015

Turbo!


Turbo and manifold installed
The turbo charger and manifold are here and already installed!
The turbo of choice is a GT35 sourced from the aftermarket (i.e. not a name brand), class type T4 with A/R (area/radius) ratio of .70 on the compressor side and .68 on the turbine side. After Ed received it he sent it out to have the seals upgraded and the rotating components balanced to a tighter specification than standard.

As anyone would know, class T4 of course defines the flow capacity (as well as flange style) which means by definition that this setup can deliver enough air for an output in the 400-800 HP range (gulp!). The A/R numbers represent just the right balance between spool-up time and output. Rather than ball bearings it uses journal bearings in order to keep it fully serviceable.

For the manifold, Ed chose a cast iron, really stout unit from ATP Turbo specifically designed for use in a turbocharged VR6 motor. It drops right in, already has the T4 style flange to match up with the turbo as well as the wastegate port.

Ed also reports that the clutch is completed to his complete satisfaction (“MUCH nicer than my 2JZ car felt like”). It has a full stroke with the expected performance stiffness and an overall fantastic “feel”.

And finally, the new Bosch EV6 injectors are on the way. These are standard issue on the 420 HP Porsche 996 Turbo with a nominal flow rate of 450cc/min each. He also tells me that these injectors are good for at least another 100 HP so, if ever needed, there is plenty of room for growth…
 
 

Friday, October 23, 2015

Water pump, remote oil filter/cooler

After a brief (and planned) break, we’re back up again! The motor has now been fitted with a water pump, tubing and thermostat housing. This is all brand new and stock VR6.
Water pump and return plumbing
Maybe more exciting is the remote oil filter/oil cooler arrangement: This is a complete SEO custom solution; sure it looks cool and makes serviceability a snap but the real driver is the fact that the stock oil filter location would have interfered with the new motor mount, so as a result, the filter was relocated. The oil cooler function may not be obvious, so to explain, the oil/coolant exchange takes place in the metal adapter that bolts to the engine block; the coolant return flow runs through the block, through the metal adapter (where it cools the oil), up the little black hose and into the coolant return pipe. Very neat.
Remote oil filter and oil cooler

In other news – the MS3 Pro Engine Management System controller is on order. This is an upgrade from the regular MS3 we had planned to go with but this way Ed does not need to add any expansion modules and such; it’s all integrated into one extremely capable unit.

Also on order is the catalytic converter. We’re going with a 3” high flow unit from APTuned, specifically for forced induction. I don’t really require a cat since they do not do emissions testing on cars older than 25 years here where I live (not sure if it is regulated at a city/county/state level) but, hey, it’s always wise to be prepared for any changes in the laws or if we move…. not to mention doing the right thing for the environment!

Ed also ordered a new 3/4" clutch master cylinder from Wilwood.... No reason to fool around with the piece of junk that I had bought from the guy who sold me the manual transmission.